Connect Cursor and Antigravity with Proxifier

  1. Download Proxifier. You can download it from the official website: https://www.proxifier.com/ Activate the 31-day trial, or find an activation code online.
  2. Download Antigravity. Download: https://antigravity.google/?hl=en
  3. Add a Proxy Server. You can find the relevant port and other data from your VPN and enter it.
  1. Add a new Proxy Rule. I proxy all relevant executables for Antigravity here. Since I use both Cursor and Antigravity, I entered all relevant ones.

  1. Open Antigravity and click Sign In With Google. Two situations might occur:

    1. If it shows region mismatch, request a change of email address region from Google. Change it to the US. I changed it to the US and used a Singapore node without any issues.
    2. If after redirection it shows unable to login, but you received a welcome email from Antigravity, then there was an issue with this login attempt. You can close the website.
      • Click Sign In again, paste the redirection URL into an incognito browser window, complete login verification, and the redirection should successfully log you in.
    3. After logging in, you might not be able to select models. Restarting the software should allow you to select models.

  2. Finally, you need to set up the HTTP proxy in each IDE. I use V2ray, so the port is 10808.

1
2
3
4
5
{
    "http.proxy": "http://127.0.0.1:10808",
    "http.proxysupport":"on",
    "http.proxystrictssL": false
}